ERCO 4022 CEL – ERCO 5022 CEL
With two motors (one for each column), controlled by an electronic card for controlling the drive synchronism of the two columns
The electronic lifts have the same main technical characteristics as the chain models.
One of their advantageous features is that they do not take up space on the ground between the columns and they are particularly quiet. A floor suitable for column fixing is required to install them. On the ERCO 4022 CEL model, the arm support carriage is guided in 8 points by shoes only.
The ERCO 5022 CEL lift, with a load capacity of 5 tons, was specially designed for lifting vans and armoured limousines, which are particularly heavy.
It is equipped with four long three-stage symmetric arms
The door protection, made of one single rubber piece, prevents the car doors from coming into contact with metal parts.
After being positioned underneath the vehicle, the arms are locked in place by an automatic anti-rotation system after the first 30 mm of travel.
Thanks to the asymmetrical arms, which allow the vehicle to be lifted further back in relation to the columns and the column outward inclination, the doors can be opened almost completely for easy access to the vehicle’s interior.
- Motor with special winding having high static torque, complete with internal overload cut-out that trips in case of overheating.
- Short telescopic three-stage arms for optimal loading of cars and vans.
- The front panel features 6 LEDs which indicate the status of the lift and the master switch (up-down selector switch).
The lift pads are at a very short distance above the ground, allowing operation even on low vehicles.
Corghi reserves the right to modify the technical specification of their products at any time without prior notice.
A Nexion Group Company
S.S. 468 n° 9 42015 Correggio (RE) ITALYTel:
++39 0522 639111Fax:
++39 0522 639150E-mail: email@example.com